EZ Clamp

Easy changeover of dies without using tools

●No tools are needed for die change
●Easy clamp by lever operation
●Speed up setup of die exchange
●Significant reduction in die changeover 

The setup time of the die is shortened and productivity improves.

EZ sheet

 NO DIE MARK WITH ULTRA FABRIC!

EZ sheet  eliminates die mark on stainless steel & mild steel etc.
EZ sheet  is a ultra-high-strength fiber.The ultra reinforced fiber of EZ sheet  is used for airplanes and bulletproof vest etc.

EZ Inspect

Traditional method of measurement reporting is very time consuming-Measure the dimensions of a part with calipers,micrometer and angle gauge etc,write down the measurement result on a piece of paper,enter the data into computer,then print the report.

Try Out EZ Inspect

Thank you for your interest in EZ Inspect. Please take a moment to register for your fully functional 30 day free trial.
All fields are required unless noted otherwise. Email address must be valid so instructions to access the software can be sent to you.